| 1. |
Disconnect the negative battery cable and keep
secure from battery.
|
Wait at least 30 seconds after
disconnecting the battery cable before doing any further
work.
| |
| 2. |
Remove the side protect cover of steering
wheel and airbag module mounting bolts using a hexagonal
wrench.
|
| 3. |
When disconnecting the connector of the clock
spring from the airbag module, pull the airbag's lock toward the
outer side to spread it open.
|
When disconnecting the airbag
module-clock spring connector, take care not to apply
excessive force to
it. | |
| 4. |
Remove the drive airbag module.
|
The removed airbag module should be
stored in a clean, dry place with the pad cover face
up.
| |
| 5. |
Remove the steering wheel using SST
(09561-11002).
|
Do not hammer on the steering wheel.
Doing so may damage the collapsible column
mechanism.
| |
| 1. |
Never attempt to disassemble or repair
the airbag module. |
| 2. |
Do not drop the airbag module or allow
contact with water, grease or oil. Replace it if a dent,
crack, deformation or rust are
detected. |
| 3. |
The airbag module should be stored on a
flat surface and placed so that the pad surface is facing
upward. Do not place anything on top of
it. |
| 4. |
Do not expose the airbag module to
temperature over 93°C (200°F) |
| 5. |
An undeployed airbag module should only
be disposed in accordance with the
procedures. |
| 6. |
Never attempt to measure the circuit
resistance of the airbag module (squib) even if you are using
the specified tester. If the circuit resistance is measured
with a tester, accidental airbag deployment will result in
seriouspersonal injury. |
| 7. |
Whenever the PAB is deployed it should
be replaced with a new one assembled with an extension wire.
The squib is melt down if the PAB is deployed makingthe
extension wire
useless. | |
| 1. |
Disconnect the battery negative (-) terminal
cable.
|
Wait at least 30
seconds. | |
| 2. |
Disconnect the PAB module
connector. |
| 3. |
Remove the crash pad assembly and then undo
the PAB module. (Refer to the BD
section) |
| 4. |
The skin of the passenger airbag module is
integrated with the crash pad, therefore, the crash pad must be
replaced if the PAB deploys. |
AIRBAG MODULE
Dispose the old one
according to the specified procedure.
|
Never attempt to measure the circuit
resistance of the airbag module (squib) even if you are using the
specified tester. If the circuit resistance is measured with a
tester, accidental airbag deployment will result in serious personal
injury. |
| 1. |
Check pad cover for dents, cracks or
deformities. |
| 2. |
Check the airbag module for denting, cracking
or deformation. |
| 3. |
Check hooks and connectors for damage,
terminals for deformities, and harness for
binds. |
| 4. |
Check airbag inflator case for dents, cracks
or deformities. |
| 5. |
Install the airbag module to the steering
wheel to check for fit or alignment with the wheel.
|
CLOCK SPRING
| 1. |
If, as a result of the following checks, even
one abnormal point is discovered, replace the clock spring with a
new one. |
| 2. |
Check connectors and protective tube for
damage, and terminals for deformities.
|
